U-he - All Synth & Effects 2017.03 (NO INSTALL, SymLink Installer)
VSTi, VST, VST3, AAX, x86 x64|[31.03.2017]|385.62 MB
All credits goes to the respective people
Description
.. ##############################
This release is intended for evaluation testing.
Support the manufacturer if you like the software
and you intend to use this software in commercial production,
in accordance with the manufacturer's license agreement.
.. ##############################
The "installation" steps are indicated in curly brackets.
Explanations (read only if necessary) are highlighted in spoilers (or triple square brackets in the txt file attached to the distribution).
{HOW TO "INSTALL" THIS PACKAGE WITH USING .CMD FILES SymLink Installer?}
Despite the following long text, the point is simple:
a) remove some folders left from old versions of the installed program, if any;
b) run only one .CMD file;
c) launching the DAW scan path for the VST2 plugins (C: \ Program Files (x86) \ VstPlugins) to start the DAW and use;
d) register, if required.
Details - below. {0} {Preinstall the required system software} If necessary, install [addon] Microsoft Visual C ++ 2005-2008-2010-2012-2013-2015 Redistributable Package x86 & x64 forum.oszone.net/thread-145766.html {1}
{Correct Unzipping of the Package}
Extract (using the 7zip archiver) the contents of the distribution from the .exe file to any drive for permanent storage, so that you do not then delete it *,
for example, in the folder:
d: \ U-he \
- not deep in the nesting folders and without Cyrillic.
* To ensure the operation of .CMD files SymLink Installer,
MOVE, DELETE, RENAME ANYTHING IN THE CONTENT OF THE DISCUSSION IS NOT AVAILABLE. {2} {Pre-cleaning of possible "remains" of the earlier versions of the package} Check the absence of folders in the places where the symlinks will be created (if the folders are left, the symlinks will not be created). For this you can, !!! saving the operating time (presets, etc.) !!! ,
(or delete if there is no uninstaller) previously installed plug-ins,
and also delete the remaining (if left) after uninstalling [End-of-Package Content
Folders ]: [
{3} {Actually "setup"}
For instant installation based on symlinks,
run the required * .CMD from the administrator (depending on the bitness of Windows 7 (and higher)),
and if necessary, change ** the paths to VST2 in .CMD files.
{4} {The final step} The
installation is complete, and then you need to open the DAW,
specify in the DAW settings an additional path for scanning the VST plug-ins: C: \ Program Files (x86) \ VstPlugins
and perform an update plug-in scan.