SKnote Verbtone v1.0.2 x86 x64 ASSiGN

Full stereo
TAP on plate to hear its sound while changing parameters!
Stereo modulation of pan, freq, amplitude and phase.

One of the last job of the Best Team

- It is a physical model of a plate reverb, plus some useful add-ons.
- It is non-linear with strong input, so input and output level controls

Parameters:

- Gain: input signal gain
- Volume: reverb output level, PRE-mix!

- Width: FINAL width of reverb tail. Reverb starts stereo (if stereo mode is set) and
evolves, ending with "Width" stereo width). Set it to max and use external pan/width control for fixed width control

- Low: hi-pass filter
- High: lo-pass filter
- Delay: predelay
- Length: reverb duration
- Sound: sets internal parameters, from a thinner plate to a thicker plate
- Tune: sets internal parameters, from lighter to heavier plate
- Vel: stereo modulation velocity
- Mod: stereo modulation amount
- Mix: mixes dry signal and reverb (reverb is post-Volume)

- Stereo menu:
Stereo->Mono->Stereo: mixes L and R to mono, then generates a stereo reverb
Split Stereo: processes L and R through two parallel plates
True Stereo: like Split Stereo but interconnects the channels/plates
Cross Split Stereo: Like Split Stereo but L and Right are inverted
Panned (Width) Mono: mixes L and R to mono and feeds both channels with mono
(may become pseudo-stereo with modulation).
Width knob becomes reverb pan!!!

- Modulation menu:
Amplitude: modulates reverb's amplitude
Frequency: applies a chorus to reverb
Phase: modulates reverb's phase (choruses with dry signal)
Pan: modulated reverb's pan

TAP on plate to hear its sound while looking for a new reverb and changing parameters!

Once you have it, try the included preset I've made, on a drum bus and tell me what you think.