please read the rules, it will answer all your questions!

  • Get the best VPN on the market with 66% Discount!
Software » Mac OSX
Nomad Factory Liquid Bundle II v2.7 AU VST RTAS Mac OSX-IND screenshot

Nomad Factory Liquid Bundle II v2.7 AU VST RTAS Mac OSX-IND

Download super-compressed 7z file @


The Liquid Bundle gives you a variety of incredible effects plug-ins. These tools are treasures for the sound designer, mixer and musician. And although these plug-ins provide intuitive and simple controls, the sound quality they deliver is full and warm. Plus, Liquid plug-ins operate efficiently to avoid over-taxing your CPU resources. Designed by musicians for musicians, the Liquid Bundle II is an essential tool for your virtual studio.

Bundle Includes:

• Liquid Compressor II
• Liquid Delays II
• Liquid Gate II
• Liquid Mod II v2.7.1
• Liquid Phase II v2.7.1
• Liquid Verb II Digital Reverb

Designed by musicians for musicians, the Liquid Bundle II is an essential tool for your virtual studio.


Liquid Compressor II

The Liquid Compressor II pumps up your sound and keeps your dynamics in check. The Liquid Compressor II can add depth and sustain to your sound while helping you cut through a mix. Easy-to-use modern interface with gain reduction light-meter. It is offered in Mono and Stereo.

Features:
• Variable Attack and Release times
• Threshold and Ratio compression with Soft/Hard Knee selector
• Internal Side Chain High and Low Pass Filters with Listen key and Bypass button
• Peak and RMS modes
• Brick-Wall Peak limiter
• Full Automation for all parameters Mac OS X
• Easy-to-use modern interface with gain reduction light-meter

Liquid Delays II

The Nomad Factory Liquid Delays II is a filtered dual-delay effect plug-in, featuring two delays, resonant filters, tube saturation-overdrive, peak-limiter and LFO. The Liquid Delays II is capable of clean-delays, dirty-delays, filtered-delays, and more. From basic synced delays to dirty, grungy, distorted delayed filters, the Liquid Delays II can create amazing effects.

Features:
• LFO Rate and Depth controls
• Sync to the host's tempo
• Dual Delay using notation values controls
• HP and LP filters controls
• Overdrive control
• Input level, Ouput level and Mix controls
• Full Automation for all parameters Mac OS X
• Easy-to-use modern interface with LFO light-meter

Liquid Gate II

The Liquid Gate II tames the noise floor so that you hear only the audio you want to keep. This fully adjustable gate/expander allows control of Threshold, Attack Time, Hold Time, Release Time and Range. To help the gate decide when to open, you can use the two Filter controls (Side Chain). Easy-to-use modern interface with gain reduction light meter. It is offered in Mono and Stereo.

Features:
• Variable Attack, Hold and Release times
• Threshold and Range
• Internal Side Chain High and Low Pass Filters with Listen key and Bypass button
• Peak and RMS modes
• Full Automation for all parameters Mac OS X
• Easy-to-use modern interface with gate reduction light-meter

Liquid Mod II

Chorus and Flanger effects operate on a very similar basis, that's why they were both implemented in the Liquid Mod II. The Liquid Mod II produces vintage tape flanging, gentle choruses, sharp phasing, phaser-emulation effects and a variety of dual-delay-modulation sounds quickly. It has the character of a vintage chorus-flanger unit using modern features options.

Features:
• Chorus or Flanger effects
• Analog or Digital processing modes
• LFO Rate and Depth controls
• Sync to the host's tempo
• Feedback control
• Overdrive control
• Ouput level and Mix controls
• Full Automation for all parameters Mac OS X
• Easy-to-use modern interface with LFO light-meter

Liquid Phase II

The Liquid Phase II emulates the sounds of classic analog phasers from the 70’s and 80’s. The Liquid Phase II provides a wealth of vintage and modern phasing effects. The selectable "Phaser Stage" control allows you to select any number of stages between 2 and 24 including all odd numbers. Using an odd number of stages sounds totally different than an even number of stages, this cool feature allows the Liquid Phase II to create unique phasing and modulation effects.

Features:
• LFO Rate and Depth controls
• Sync to the host's tempo
• Analog or Digital processing modes
• Low and High frequency stages contour
• Overdrive control
• Ouput level and Mix controls
• Full Automation for all parameters Mac OS X
• Easy-to-use modern interface with LFO light-meter

Liquid Verb II

The Liquid Verb II Digital Reverb is a great professional reverb for music and post-production applications. From spacious concert halls to small rooms, the Liquid Verb II delivers professional-quality reverb and ambience processing to the most demanding studio sessions. Designed to be musical, the Liquid Verb II is easy to use with just a few controls and a simple modern interface.

Features:
• Small, Medium and Large reverberation times. (0.1 to 10 secs)
• Three band equalizer with Pre/Post reverberation.
• HP and LP Filters section (post reverberation).
• Pre-Delay and Reverb time (RT60)
• Wet and Dry level controls.
• Input and Output level controls.
• Full Automation for all parameters Mac OS X
• Easy-to-use modern interface.
download from any file hoster with just one LinkSnappy account
download from more than 100 file hosters at once with LinkSnappy.

comments

  Banned 13.05.2011 801 3875
+23575
- AU 32 bit
- AU 32+64 bit
- VST 32 bit
- VST 32+64 bit
- RTAS


E N J O Y ! wink

  Resident 3.01.2011 1 4432
+559
thanks
  Resident 9.04.2011 1 753
+112

7zip archive: 5,654,590 bytes
uncompressed: 63,954,368 bytes (1,260 files)

wow WOW! wow
.....::::: The best warez are yet to come :::::.....
  Resident 30.01.2010 1 1661
+277
Presets are Windows Versions and do not work ! Plugs are ok
***MSJ=X***
(Retired)
  Resident 7.02.2008 70
+13
the next TOBW is always brings so much fun in here .. gracias mate
Semper Fi
  Resident 29.04.2012 920
+23
THX Kookaboo wink phones
  Resident 29.01.2012 2060
+215
crappy

Are you really sure? I already have these presents and they work fine
  Resident 21.03.2012 511
+87
Thx Kook
  Resident 19.09.2012 155
+7
thx a lot!
:) Kook, Air and IND!
  guest -- 0
0
I was unable to use properly the auth tool kit; when I try to read the .auth files from NF Manual Activation.app it doesn't work. Could you better explain the activation procedure?
  Resident 29.01.2012 2060
+215
gurdjieff

You have use Software Activation tool not NF Manual Activation its dead easy
  Member 3.10.2012 15
0
Sorry, not super easy... followed all instructions in read me (mac osx), still runs demo mode... any help please?
  guest -- 0
0
Rums30,
Until you mentioned the demo status, I did not realize that my installs from sometime ago were still in demo mode. The solution is to use Manual Activation to load the license files. All four files have to be done separately, on after the other. These are the files produced by the Keygen. Good luck!
  guest -- 0
0
psyko67,

Hi psyko67, thank you for your reply. In the instruction file I read:


1) Start the "Software Activation" tool and choose OFFLINE activation
2) Use fake data for email and serial number, click 'AUTHORIZE'.
3) An auth request file has been saved to your desktop. Leave the activation tool running.
4) Start the keygen, click 'Read Auth Request', load the .html file on your desktop.
5) BBE Sound.auth, ECHO.auth, MAGX.auth and Nomad Factory.auth Magx.auth will now be in the same location as the .html file

6) In the Nomad Factory manual activation tool click 'Read License File'

7) Load Magx.auth, Echo.auth and Nomad Factory.auth to activate the NF Bundle

(Magx.auth activates the new Magnetic Plugin)
(Echo.auth activates the new Echoes Plugin)

8) Have Phun!


Could you write here your procedure please?

G.
  guest -- 0
0
If I may reply; all instructions follow clearly. The only addition is to add each AUTH files separately. You will need to close and reopen the Manual Activation tool for each activation file. The manual activation tool rests on your mac desktop, along with the kept open "software activation" tool. The Keygen rests inside your Windows partition. Transfer the AUTH files from the windows partition to your mac desktop
in order to activate.

Hope this made sense.
  Resident 19.04.2012 258
+26
NF Manual Activation and Software Activation dont launch...
  Resident 7.10.2011 8 97
+279
Fake :)
Signature
  guest -- 0
0
I had no problems launching either of them. All plugs are working even the one previously installed from elsewhere.

There is nothing wrong with the upload.

Thank you!
  Resident 29.01.2012 2060
+215
RIIJ

Why you keep talking about manual activation tool since what you need to use is Software Activation Tool like it said in read me.

tele

Use Permission reset to fix permissions, its free use google to find it
  guest -- 0
0
Psyko67
We can all read and I am sure that you do too.

The point of exit for most people's problem, as it had been mine, is using the manual activation tool to Install the license files.
Three tools are used to achieve result; 1. SOFTWARE ACTIVATION, 2. WINDOWS KEYGEN, 3. MANUAL ACTIVATION TOOL.

Thats what I followed as per the instructions with no deviation, and it worked for me.
  guest -- 0
0
I've tried in any way but It doesn't work for me on Lion; simply, when i try to authorize the "xxx.auth" file (from Software Activation or NF Manual Activation using "read license file" - no differences) the auth software doesn't work. I tried also to fix permissions....

Any suggestion will be really appreciated!
  guest -- 0
0
Sorry, I am on Snow Leopard, can't help. Maybe you can check to see if the license files were placed in the location as directed on the Manual activation tool.
I know nothing about Lion.
  guest -- 0
0
Thanks RIIJ, so the problem could be the OS version...there are Lion users with no problems?
  guest -- 0
0
I don't know for sure, I checked the website and it did not say anything about Lion compatibility.


What version of Mac OS is compatible with my Nomad Factory Products?
We support Mac Intel machines runing Mac OS Leopard 10.5 and Snow Leopard 10.6 (including 64 bit).
Sorry we do not longer support Power PC machines and Mac OS 10.4 (Tiger) or earlier.
  Member 3.10.2012 15
0
Still no luck, can't tell if I missed something or what... I did the following:
1. Transferred the vst files in to my vst folder
2. Did the offline activation steps
3. Tried Software Activation Tool and Manual Activation, loaded the license files (never showed it doing anything, assumed done, quit. did again after it didn't work).
4. Switched the permissions of the license files.
5. Restarted my computer each time it didn't work and tried again. Still in demo mode.

Did I miss something? Am I supposed to transfer something else?

Thanks!
  guest -- 0
0
Yes, you missed something. You missed the part about adding the KEYGEN to a windows partition, import the HTML file into the KEYGEN,
then placing those 4 "auth" files unto your mac desktop, then import each separately into the manual activation tool. The MA tool will install the license files. If however you are using LION, these instruction might not help. Please check the plugins website to see if Lion is supported.
  Member 3.10.2012 15
0
Did that, summed it up in the offline activation steps, I assume this is the part that makes those 4 .auth files on my desktop (that won't do anything when I load them with the activation). I think it's a Lion problem... Thanks though, you guys are awesome.

What program do you guys use to open .exe in mac??
  Resident 29.01.2012 2060
+215
Still you talking manual manual activation tool why? If you read those instructions keygen folder. It can't be that hard
  Member 3.10.2012 15
0
I tried manual and normal, neither work for os x lion.
  Resident 29.01.2012 2060
+215
Works on Mountain Lion

related posts

Nomad Factory All Plugins Bundle v4.0 MacOSX-XdbNomad Factory Blue Tubes Dynamics Pack v3.6 AU VST RTAS Mac OSX-INDNomad Factory Essential Studio Suite v1.7 AU VST RTAS Mac OSX-IND

Spread the Word